Adjustable Phone Stand Tripod, Desk or Photography
Adjustable Phone Stand Tripod, Desk or Photography 1Adjustable Phone Stand Tripod, Desk or Photography 2Adjustable Phone Stand Tripod, Desk or Photography 3Adjustable Phone Stand Tripod, Desk or Photography 4Adjustable Phone Stand Tripod, Desk or Photography 5Adjustable Phone Stand Tripod, Desk or Photography 6
Alet ve Ekipman

Adjustable Phone Stand Tripod, Desk or Photography

900,00 TL

Ödeme şekli: Sadece nakit

Ürünü İndir · MakerWorld
Paylaş
  • Ankara içi elden teslim
  • Teslimatta nakit
  • Renk/ölçü isteğe göre

Ürün Detayları

Boost Melike the model?MembershipDo you want to sell this model? Check out the commercial license!Here is my take on a sturdy versatile tripod for phone photography. Features: Nice wide tripod base twist, pivot, and swivel adjustments selfie stick stabilization tool included textured grip areas fully 3d printed There are a few fits that i made tight intentionally (0.1mm), but there is clearance everywhere and everything goes together well. Dry your filament clean your bed use glue calibrate your filament Assembly process: • Insert the “legs” into the “leg pivot ring”, one at a time. You may need to rotate and angle the legs to get the pivot side through the ring. seat the pivot portion of the leg in the slots as shown in the picture below. Then place a “leg friction” piece on top of each leg pivot as shown in the image below. 2. Select either the “tilt” part or the “extended tilt column” and place it on top of the assembly from the previous step. Then place the “tilt lock” ring over the leg pivot ring screwing the two together. make sure no other pieces fall out of place while tightening the ring down. 3. Place the “mount arm” onto the previous assembly and align the holes. insert the “arm lock” through the hole in the “mount arm” screwing into the “tilt nut” as shown in the image below.  4. insert the “ball dowel” into the “ball screw” and cap with the “ball bottom” as shown in the image below. 5. Insert the previous ball assembly into the previous mount arm assembly and screw the “ball tension knob” in as shown in the image below. 6. Place claw 1 onto the ball screw and secure with the “claw to ball nut” using the “tool” to tighten. slide "claw 2" over “claw 1” and screw the “claw nut” down as shown in the images below. Bu ürünün çizimi MakerWorld'den alınmıştır. Yapımcıya teşekkür ederiz. Bu ürün tasarımcının izniyle üretilmektedir. Tasarımcı: COMRADE_ZACH · Lisans: Standard Digital File License

Bu ürünü farklı renk, ölçü ya da malzemeyle mi istiyorsunuz? Özel baskı siparişi verin.

Benzer Ürünler

Tüm Alet ve Ekipman ürünleri