Windup Flying Butterfly
Windup Flying Butterfly 1Windup Flying Butterfly 2Windup Flying Butterfly 3Windup Flying Butterfly 4Windup Flying Butterfly 5
Oyuncak ve Oyunlar

Windup Flying Butterfly

250,00 TL

Ödeme şekli: Sadece nakit

Ürünü İndir · MakerWorld
Paylaş
  • Ankara içi elden teslim
  • Teslimatta nakit
  • Renk/ölçü isteğe göre

Ürün Detayları

Boost MeOver the past weeks I put a lot of love, sweat and tears into this project trying to get these little creatures to fly. And when the first prototyped worked I was so happy!! If you enjoyed this butterfly as well, boosting would make my day. Thank you so much!!Windup Flying Butterfly Add a lovely touch of magic to your birthday cards and book gifts with this butterfly!  Simply wind it up, place it inside and watch how this charming butterfly puts a smile on everyones face. It still amazes me every time! Check out my other models! https://makerworld.com/de/models/1677919-chainsaw-key-cover#profileId-1777218 Print in Place Front Loader https://makerworld.com/de/models/1628896-front-loader-print-in-place#profileId-1720088 Instructions • Printing it Clean your build plate for good bed adhesion. Make sure your filament is dry. If this is your first time printing it, try out the single color or half pattern version, those are lighter and fly easier. Then try out the full pattern version. • Taking it off the build plate First, let your build plate cool down as far as possible (less than 25 °C / 77 °F), you can take it off the printer to speed up this process. Next, bend your build plate, this should loosen up the print, then you can carefully pull the butterfly of. If it doesn't come off, try going under it with your fingernail, if it still does not come off, your build plate was not clean enough. • Winding it up For strong flights: Take a 45 mm (diameter) rubber band twice and wind it up until it becomes difficult (around 50x) For short flights (if you don't want to scare people) Take two or three 20 mm (diameter) rubber bands and wind it up until it becomes difficult (around 50-60x) • Place it in a card or book Place it facing upwards and a little bit outwards, that way it will fly high up and not in the persons face :)  Important: I have tried out many rubber bands and the ones that actually worked best and that were strong and durable were the ones from  Bambu Lab's Maker's Supply, so if your's doesn't fly, please order them from there!  If you have the Maker's Beginners kit, you also have some 20 mm rubber bands, you can take 2/3 of them. Bu ürünün çizimi MakerWorld'den alınmıştır. Yapımcıya teşekkür ederiz. Bu ürün tasarımcının izniyle üretilmektedir. Tasarımcı: Benni's Creations · Lisans: Standard Digital File License

Bu ürünü farklı renk, ölçü ya da malzemeyle mi istiyorsunuz? Özel baskı siparişi verin.

Benzer Ürünler

Tüm Oyuncak ve Oyunlar ürünleri